HORSEPOWER TV'S "BANG FOR THE BUCK" DYNO TESTS

"Which parts add the most performance at the lowest cost?" It's the question every gearhead asks before he starts building up his engine.

Now there is an answer! Using it's new DTS PowerMark engine dyno, HorsepowerTV tests specific parts combinations for specific engines at specific prices! Now you can get more than just peak advertised numbers, down load this page and then use our "where to buy" button to get you the lowest price on the combination tested!

   
 

Small Block Chevy Test HP0602

HORSEPOWER DYNO RESULTS
ENGINE BASELINE                                       ENGINE MODIFIED*
Horsepower: 290 @ 5100 rpm                    Horsepower: 411.9@ 5800 rpm
Torque: 326 lbs/ft @ 3750 rpm                    Torque: 419.8lbs/ft @ 4500 rpm

Average Modified Data
Horsepower 359.0      Torque 391.4


For the second round of our small block Chevy testing, we installed a parts combination that upgrades our GMPP 290 hp 350 dyno mule into a late-model Vortec style small block.  This package includes Edelbrock’s new Top End Kit with 170cc E-Tec aluminum heads, Performer RPM Air Gap dual-plane intake, Edelbrock hydraulic roller cam and all required fastners and gaskets.  To that we added new hydraulic roller tappets from Crane, shorter length pushrods from Summit Racing and a set of Summit 1.6 ratio roller rocker arms.  We topped it all off with an Edelbrock “Thunder Series” AVS carburetor.  This parts combination raised performance throughout the curve delivering a peak 411.9 HP @ 5800 rpm (121.9 HP gain) and maximum torque of 419.8 lb/ft @ 4500 rpm (93.8 lb/ft gain).  The cost of this particular combination is $2770.75 meaning each additional pony cost us approximately $54 bucks.

CLICK HERE TO
DOWNLOAD THIS PAGE

 

PACKAGE INSTALLED
The part combination installed was sourced from Summit Racing Equipment. It includes the following components:

  1. Edelbrock Top End Kit
    EDL – 2099
  2. Edelbrock AVS 800 cfm carb 
    EDL – 1813
  3. Crane hydraulic roller lifters
    CRN – 11532-16
  4. Summit shorter push rods  
    SUM – 1457200
  5. Summit 1.6 roller rocker arms 
    SUM – G6920B

The combination is available as package    
SUM – CBB2  price  $2770.75

Click on the Summit logo below for more information on this combination, this crate engine and related parts 





When installing a retrofit hydraulic roller cam into an early engine, always verify that you have the correct pushrod length and rocker arm geometry.


* Performance figures recorded at the PowerBlock Tech Center Franklin, TN using 87 octane fuel on the HorsepowerTV DTS PowerMark engine dyno.  Data corrected for standard operating conditions. Results may vary based on weather, altitude and fuel type used.  Timing 32º @ 2500 rmp. Exhaust: Dynatech 1 7/8” headers; Flowmaster 40 series mufflers 3.5”